Instruction Manual

15 Installation pushbutton
1
2
3
4
5
5
Figure 9: Installation pushbutton
Table 7: Installation pushbutton - instructi on s
Nr. Work step Note
1 Loosen the covering in the oddments tray of the center console usin g a trim tool.
2 Route the cable for the pushbutton, using a pull t hr ou gh aid, under the carpet and
the trim panel in the oddments tray of the center console.
3 Pull the cable for the pushbutton further through and doing this, pay att ention that
the pushbutton isn’t damaged.
4 Drill a suitable hole for the pushbutton in the covering of the center console. 7mm
5 Install the pushbutton at the cover i ng and rei ns t all th e covering afterwards.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 14