Instruction Manual

13 Cable routing to the sound generator
1
2
2
3
4
5
Figure 7: Cable routing to the sound generator
Table 5: Cable routing to the sound generator - instructions
Nr. Work step Note
1 Route the connecting cable of the sound generator along the sill trim backward to
the side trim panel.
2 Guide the connecting cable behind the side trim panel to the back seat and pull it
out from behind.
3 Afterwards guide the connecting cable under the carpet in the trunk.
4 Pull the connecting cable further through and route it to the grommet in the spare
wheel recess.
5 Guide the connecting cable through the grommet to the underbody.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 12