Instruction Manual

12 Control unit connection / pushbutton installation
1 2
3
3
Figure 6: Control unit connect i on / pushbutton installation
Table 4: Control unit connection / pushbutton installation - instructions
Nr. Work step Note
1 Connect the control unit to the cable set and attach it to the marked place.
2 Connect our module to the cable set and attach it to the marked place.
3 Drill a hole at the marked spot for the pushbutton and install it. 7mm
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 11