Phau Ntawv Qhia

16 Routing connecting cable sound generator to the underbody
1
2
3
4
4
4
Figure 9: Routing connecting cable sound generator to the un de rbody
Table 7: Rout i ng conn ec t in g cable sound ge ne rat or to the under body - instructions
Nr. Work step Note
1 On the right side in the trunk, guide a pull through aid along the cable chann el in
the direction of the back seat, until you come out at point 2.
2 At tach the connecting cable for the sound generator to th e pull through aid and
then pull it under the trim panel of the c-pillar into the trunk.
3 Route the connecting cable along the cable harness on the right side to th e trunk sill
protection and further at the original cable harness along the arrows to the marked
grommet on the left side in the trunk.
4 Now guide the connecting cable through the marked grommet (to the right of the
control unit) to the underbody w it h a pull th r ough aid .
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 15