Phau Ntawv Qhia

12 Cable routing to the sound generator
1 2
3
4
4
5
Figure 6: Cable routing to the sound generator
Table 4: Instructions for the cable routing to the sound generator
No. Work ste p Note
1 Route the cable set, which was connec t ed with the control unit and the module
before, to the marked rubber grommet in the footwell at driver’s side.
2 Aftterwards pull the cable out through the marked rubber grommet into the engine
bay at driver’s side, by using a pulling aid.
3 Route the cable set further to the left to the water tank , then it should comes out
behind the brake boost er .
4 Then route the cable behind the steering gear along the splash wall upwards.
5 The cable is routed downwards along the splash wall in th e direction to the gear
holder and gets protected with respective cable ties.
Please note: When routing the cable along the exhaust pipe, a respecti ve distance
must be kept absolutely due to the intense heat development !
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 11