Instruction Manual

10
Connect the CAN wires to the red plug of the CAN gateway according to the cable colours and Pin
numbers named below. It is located below the dashboard on the driver’s side, fig. 14. To establish the
connections, move the red plug off, fig. 15. Insulate the connection points afterwards!
Fig. 14 Fig. 15
Finally, you have to install the pushbutton for the switch of the sound profiles, e.g. below the dashboard
front left, fig. 16.
Fig. 16
The reassembly is made in reversed order. See to a can bus sleep mode of at least 10 minutes (lock
vehicle). Thereafter the installation is completed.
You can switch the sound profiles with the pushbutton. You can choose between 6 sound profiles. In
profile 1-3 you hear a restrained sound, in profile 4-6 it’s a powerful V6/V8 sound.
CAN High (black/white) - Pin 16 (orange/black)
CAN Low (black/yellow) - Pin 6 (orange/brown)
Attention: For the drilling, a 7mm drill is necessary!