Instruction Manual

3
Safety instructions
The installation can be executed only by trained qualified personnel. Before the installation disconnect
the power supply. Therefor cut off the battery from the vehicle electric system, follow the manufacturer’s
specification.
• Never use bolts, screws and other fastening elements from car’s safety devices or steering
wheel, brakes because it may influence your driving safety and cause accidents.
• Connect the device only to a 12V vehicle voltage with chassis ground. This unit cannot be used in
large trucks or other vehicles which use a DC 24 V battery wiring system voltage.
• Avoid to install the device in places where it could hinder the safe driving or functional efficiency
of the other units installed in the vehicle.
• This unit is only for the use with the following vehicles and model line; Only connections
described within this instruction manual are allowed or required to use for installation.
• For damage impact caused by faulty installation, unsuitable connections or assembling in
inappropriate vehicle types or models Kufatec GmbH &Co.KG assumes no liability.
• We advise you that these units process data out of the MOST protocol from the vehicle. During
the assembly of this unit we as supplier have access to a specific model and we as producer don’t
know the overall system you work with.
• Especially in case of changes within the same model line and the same model year we don’t
guarantee the usability of our products. In case of the usability of our products with the
manufacturer’s changes Kufatec GmbH assumes no liability.
• Kufatec GmbH assumes no liability that the assembly of the unit described in this manual is
approved according the warranty regulations of the single car manufacturers. Please check your
manufacturer’s conditions and warranty before you begin the installation.
• Kufatec GmbH reserves the right to change the device specification without further notice.
• Errors and changes excepted.
References of legal regulations for operation
Use this unit in the intended domain only.
If you use the unit in a foreign domain, if the unit is not installed properly, or if the unit will be
reconstructed the operating permit and warranty will expire.