Instructions / Assembly

3
INFLATION PROCEDURE
DO NOT USE AN AIR COMPRESSOR. It will result in damage to the board, and will void all
warranties. Maximum air pressure for this product is 15 PSI. DO NOT INFLATE BEYOND 15
PSI. Inflatable SUP boards are not warranted against over inflation.
10 PSI is a good choice to start with.
1. Choose a smooth surface to assemble your board.
2. Remove the board from the backpack and unroll it.
3. Attach pressure gauge to hose and then attach
pressure gauge to pump.
4. Attach other end of hose to the inflation/deflation valve
on the rear of the board as shown below.
5. Stand the pump on hard, level ground and start to pump.
The first time you inflate the SUP will require more
effort than subsequent inflations.
6. Make sure you keep your hands toward the center of
the pump handles when pumping and your feet firmly
on the footrest of pump.
Use the board at a pressure between 8 - 15 PSI. The final few PSI is the key to getting
maximum performance from your board.
FIN INSTALLATION
Turn board over with slot for
fin facing up. Slide fin in slot
all the way to the end. Take
pin and slide through the
side of the slot, through the
fin and then through the other side
of the slot."