Dimensions Guide
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
Installation Introduction
16
Electrical Grounding Instruction:
1. The power cord is equipped with a three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to minimize the possibility of
electrical shock hazard from the range.
2. All cord connected appliance shall include instructions relative to location of the
wall receptacle and a warning to the user to disconnect the electrical supply before
serving the appliance.
3. Where a standard two-prong wall receptacle is encountered, it is the responsibility
and obligation of the customer to have it replaced with a properly grounded
three-prong wall receptacle. Do not cut or remove the grounding prong from the
power cord.
CAUTION:Label all wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation. Verify proper operation after
servicing.
Connect Range to Gas Supply
1. Install a manual gas line shut-off valve in the gas line in an easily accessed location
outside the range in the gas piping external to the appliance for
the purpose of turning
on or shutting off gas to the appliance.
2.
Install male
1
/
2
” flare union adapter to
1
/
2
” NPT internal thread elbow at inlet of
regulator. On models equipped with standard twin burners, install the male pipe thread
end of the
1
/
2
” flare union adapter to the
1
/
2
” NPT internal thread at inlet of pressure
regulator. Use a wrench on the regulator fitting to avoid damage.
3.
Install male
1
/
2
” or
3
/
4
” flare union adapter to the NPT internal thread of the manual
shut-off valve, taking care to secure the shut-off valve to keep it from turning.
4.
The gas supply pressure for checking the regulator setting is 6 in.w.c. (Nature Gas)
and 11 inch.w.c. (LP gas) connect flexible gas line connector to the regulator on the
range. Position range to permit connection at the shut-off valve.
This indoor gas cooking appliance is equipped with a three-prong(grounding) plug
for your protection against shock hazard and should be plugged directly into a
properly grounded three-pronged receptacle.
DO NOT cut or remove the grounding prong from the plug.