Instructions / Assembly

Proceed if you would like to mount this range hood using the provided hood mounting bracket (If included).
1. Using references in the Location Requirements section, mark the leveling point of the hood. Position two mounting
screws on the wall, leaving 1/8” space away from the wall. Mounting the hood on wall studs is highly recommended.
2. Attach the hood mounting bracket to the back of the hood with four screws as shown in Figure 3.
3. Puncture the knockout wire access hole at the back of the hood and draw the electrical wires.
4. Align hood-mounting brackets to the screws on the wall and hook the hood into place as shown on the next page.
5. Tighten screws to secure hood to the wall.
CAUTION: Make certain the range hood is fully secured before releasing!
INSTALLATION GUIDE AND USER MANUAL
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
ATTENTION HOMEOWNER
STEP 1 | METHOD A
Two people will be required to lift and install the main unit. We highly recommend professional help and an extra set of
hands.
Measure the distance between the stove top and the bottom of the range hood. A distance of 24” to 32” is
recommended.
There are two methods (A or B) to mount the range hood, choose the one that better ts your setup and model.
Proceed if you would like to mount this range hood without using the hood mounting bracket.
1. Using references in the Location Requirements section, center the hood beneath the cabinet and ush with the front
of the cabinet.
2. Draw the electrical wires through the cabinet access opening if not done so already.
3. From inside of the hood, place screws into the exact center of each knockout hole and secure to cabinet bottom. Finish
tightening all screws until secure. Be careful when using electrical screwdrivers, they may cause damage to the range
hood.
Skip Method B below and proceed to step 2.
CAUTION: Make certain the range hood is fully secured before releasing!
STEP 1 | METHOD B