Instructions / Assembly
INSTALLATION GUIDE AND USER MANUAL
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
STEP 2
For safety purposes, pre-drilled mounting holes are provided through the back of the hood. For a more secure
installation, use as many mounting holes as needed to secure the unit from the inside of hood.
STEP 3
Use a 8"diameter (size may vary) venting pipe (follow building codes in your area) to connect the exhaust on the hood
to the ductwork above. Use HVAC foil tape / duct tape to make all joints secure and air tight.
SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make sure this is done by
qualied electrician in accordance with all applicable national and local electrical codes. Before connecting wires, switch
power o to prevent power from being switched on accidentally.
STEP 4
Connect the range hood to a designated standard outlet or cut o the plug and connect three wires (black, white and
green) to house wires and cap with wire connectors. Connect according to colors (i.e. black to black, white to white, and
green to green.) (If applicable).
STEP 5
Store excess wires in the wiring box.
STEP 6
Place oil tray into recess support near the rear of the hood. Refer to Figure 6.
STEP 8
Turn power ON with Control Panel. Check all lights and fan operation
STEP 7
To install bae lters, refer to Figure 7 for placement.
1. Angle bae lter toward the back of hood.
2. Push bae lter up until almost leveled.
3. Slide iforward into recess behind the front of the hood.
4. Lower the bae lter.
5. Slide back until it ts into resting position.
Make sure to leave this installation guide for the homeowner if you are a contractor.