Specification

Clean the door gasket
Clean the door gasket with a damp cloth to remove
food
particles regularly.
Inside
The inside of the dishwasher is self-cleaning with
normal
use. If needed, clean the tub gasket with a
damp
cloth and use a brush similar to the ones shown
below
to clean the opening in the end of the gasket.
Air gap
If there is an air gap installed with your dishwasher,
make
sure it is clean so the dishwasher will drain
properly.
Air gap is not part of your dishwasher.
Before you clean the air gap,turn off the dishwasher
firstly
and lift off the cover
Remove the plastic cap and clean with a toothpick.
Protect against freezing
Your dishwasher should be protected from freezing
properly
if it was left in an unheated place Have a
qualified
person do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the
supply
source by moving fuses or tripping circuit
breaker.
2. Turn off the water supply
3. Place a pan under the inlet valve.Disconnect water
line
from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water
into
pan.
To Restore Service:
1.Reconnect the water,drain and electrical power
supply.
2.Turn on water and electrical power supply.
3.Fill both detergent cups and run dishwasher through
a Heated-Wash cycle.
4.Check connections to make sure they do not leak.
17
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM