Quick Start Guide

15
Take care of KUBOTake care of KUBO
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operaon
is subject to the following two condions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operaon.
Changes or modicaons not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instrucons,
may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in
a parcular installaon.
If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This equipment complies with FCC radiaon exposure limits set
forth for an uncontrolled environment. This transmier must not
be co-located or operang in conjuncon with any other antenna
or transmier.
ISED Compliance
This device contains licence-exempt transmier(s) that comply
with Innovaon, Science and Economic Development Canada’s
licence-exempt RSS(s).
Operaon is subject to the following two condions:
1. This device may not cause interference.
2. This device must accept any interference, including interference
that may cause undesired operaon of the device.
L’émeeur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovaon, Sciences et Développement
économique Canada applicables aux appareils radio exempts de
licence. L’exploitaon est autorisée aux deux condions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est suscepble d’en compromere le
fonconnement.
This equipment complies with IC RSS-102 radiaon exposure
limits set forth for an uncontrolled environment. This transmier
must not be co-located or operang in conjuncon with any other
antenna or transmier.
Cet équipement est conforme aux limites;exposion aux radiaons
IC CNR-102 établies pour un environnement non contrôlé. Cet
émeeur ne doit pas être situé ou fonconner conjointement avec
une autre antenne ou un autre émeeur.
Hereby, KUBO Robocs ApS declares that the radio equipment
type KUBO20 is in compliance with Direcve 2014/53/EU.
The full text of the EU declaraon of conformity is available at the
following internet address: www.kubo.educaon
FCC ID: 2AOWV-KUBO-20
IC: 25509-KUBO20
Bluetooth: 2402MHz-2480MHz, -0.82dBm
RFID: 13.56MHz, -15.93dBuA/m
Soware version: 20
Accessories: Charging cable for KUBO robot. TagTiles.
Operaonal
informaon: This Quick Start Guide.
Brand: KUBO
Model: KUBO20
Do not disassemble KUBO. Doing so will void any warranes,
implied or otherwise. Be careful when handling KUBO. Applying
excessive force, or dropping it may cause permanent damage.
To reduce the risk of re and burns, do not aempt to open,
disassemble or service the baery pack. Do not crush, puncture,
short external contacts, expose to temperatures above 60°C
(140°F), or dispose of in re or water. Baery chargers used with
the device are to be regularly examined for damage to the cord,
plug, enclosure and other parts and, in the event of such damage,
must not be used unl the damage has been repaired. Baery is
3.7V, 800mAh (3.7*0.800=3Wh). The max operang current is
1300mA.