User Manual
Handling the measuring wire
The wire must be extracted from the sensor
vertically.
Do not pull directly on the wire. This might
kink the wire. Do not operate the sensor if
the wire is kinked or damaged. This might
damage the sensor.
When installing or operating the sensor,
take care not to let the wire snap back by
mistake or extract the wire beyond the
specified measurement range, as this might
destroy the sensor.
Avoid guiding the wire over edges or corn-
ers.
One or if necessary several deflecting pul-
leys can be used to change the extraction
direction of the wire.
The maximum deviations from the vertical
is 3°. Avoid carefully extracting the wire at
an inclination, since this would shorten con-
siderably the service life of the appliance.
If the 3° limit cannot be kept, a deflecting
pulley has to be used
R62816.0009 - Index 2