Datasheet

633
8H
8H
ø19
29±1
120°
ød2
ød1
Gewindestifte
1,95
Gewindestifte
M3x4 DIN916 (4x)
22±1
2,0
Accessories
www.kuebler.com© Fritz Kübler GmbH, subject to errors and changes. 07/2016
Accessories
Dimensions
Dimensions in mm
Bellows-type coupling ø 19 [0.75]
(8.0000.1102.XXXX)
Bellows-type coupling ø 15 [0.59]
(8.0000.1202.XXXX)
Spring washer-type coupling, one-part
(8.0000.1301.XXXX)
Spring washer-type coupling, three part, plug-in
(8.0000.1401.XXXX)
Bellows-type coupling ø 25 [0.98]
(8.0000.1502.XXXX)
Installation instructions
1. Check shaft for displacement; see technical data for details.
2. Align and adjust coupling on shafts.
3. Tighten locking screws carefully. Avoid overtightening.
4. During installation protect the coupling from damage and from overbending.
Couplings Bellows and spring washer couplings
Accessories
Connection of motor and encoder
Metal bellows-type couplings (.1102, .1202 und .1502) Spring washer-type couplings (.1301 und .1401)
Metal bellows-type couplings are recommended as an inexpensive type of
coupling. They are also suitable for compensating larger angle displacements.
Spring washer couplings are used primarily where high speeds and minimal
axial errors occur. For applications requiring potential separation between the
encoder and the drive, use the electrically isolating spring washer coupling.
set screw
M3x4 DIN 916 (4x)
socket cap screw
M2.5x8 DIN 912 (2x)
socket cap screw
M3x10 DIN 912 (2x)
set screw
M3x4 DIN 916 (4x)
set screw
M4x6 DIN 916 (4x)