Instructions / Assembly

6
5 Measure the Tubing
Ten feet of plastic tubing are provided
for your convenience. Determine the
length of tubing required to connect
the elbow fittings on the back of
Kube to the two new adapters.
6 Cut the Tubing
Place the tubing on a clean, flat surface like
a cutting board. Do not kink the tubing. Using
a sharp utility knife, make a perpendicular cut
to your measured length of tubing.
7 Connect the Tubing
Locate the connections on the back of
your Kube. As indicated by the graphic
in Step 5, connect the upper fitting with
the faucet picture to the male adapter.
Connect the lower fitting with the supply
valve picture to the female adapter. Tip:
The upper connection goes up to your tap,
the lower connection line connects to your
source water valve.
8 Check the Tubing
Place a mark at 3/4” from the end of
the tubing before you begin inserting
into the elbow fittings and adapters.
Firmly push the tubing 3/4” into both
the elbow fittings and the adapters. Push
and pull the tubing toward and away from
the fittings to ensure that the tubing has
been installed properly and is locked in
place. To remove tubing, depress and hold
the collet; pull the tubing out to remove.
Engagement 3/4"
Insert Tubing
From Cold
Water Line
To Cold
Water
Faucet