Daim Ntawv Qhia Tus Neeg Siv

212Control Surfaces Support Guide for Logic Pro
Yamaha DM2000 Aux Select controls in Logic Pro
The table outlines the AUX SELECT controls and their assignments.
Note:A modifier button (such as USER 4, preassigned to SHIFT/ADD) shown below a
control description indicates that the control has an alternate use while the modifier is held
down. Modifier buttons that need to be assigned manually by the user are shown with an
asterisk (*) that precedes the button name.
Control Modifier Assignment
AUX 1 In Insert Display mode:
• Assigns Send 1 level of channel
strips to encoders.
• Assigns Send 1 level of the
selected channel strip to virtual
encoders.
• Assigns Sends 1 to 4 of the
selected channel strip to virtual
encoders. Use the ENTER button
to switch the bypass state of
Sends 1 to 4.
In Channel Display mode:
• Assigns Send 1 level of channel
strips to encoders and virtual
encoders.
Shows current Send 1 destination
assignment, when button is held
down.
*USER 4 Same as AUX 5, but for Send 6
AUX 2 Same as AUX 1, but for Send 2
*USER 4 Same as AUX 5, but for Send 7
AUX 3 Same as AUX 1, but for Send 3
*USER 4 Same as AUX 5, but for Send 8
AUX 4 Same as AUX 1, but for Send 4
AUX 5 In Insert Display mode:
• Assigns Send 5 level of channel
strips to encoders.
• Assigns Send 5 level of the
selected channel strip to virtual
encoders.
• Assigns Sends 5 to 8 of the
selected channel strip to virtual
encoders. Use the ENTER button
to switch the bypass state of
Sends 5 to 8.
In Channel Display mode:
• Assigns Send 5 level of channel
strips to encoders and virtual
encoders.
Shows current Send 5 destination
assignment, when button is held
down.