Daim Ntawv Qhia Tus Neeg Siv

194Control Surfaces Support Guide for Logic Pro
Control Assignment
Moving virtual encoders 1 to 4
(Use cursor keys, and then rotate
parameter wheel.)
Pan Assignment mode:
• Parameter control 1 edits pan or surround angle.
• Parameter control 2 edits surround diversity.
• Parameter control 3 edits surround LFE.
• Parameter control 4 edits spread.
Send Assignment mode:
• Controls the Send level of Sends 1 to 4 or 5 to 8.
Plug-in Assignment mode:
• Chooses Insert slot 1 to 4 or 5 to 8.
Plug-in Edit mode:
• Sets value.
Yamaha 02R96 LCD display in Logic Pro
The LCD displays different data, depending on the page selected with the F2, F3, and
F4 buttons:
• INSERT ASSIGN/EDIT Display view: Parameter details, plug-in selection, or plug-in
parameters. Press F2 to select this view.
• Channel view: Encoder values and channel strip display. Press F3 to select this view.
• Level meters view: Press F4 to select this view.
The following assignments are available in all three views:
Display Assignment
TIME CODE Active if counter is displaying SMPTE timecode.
BEATS Active if counter is displaying bars/beats/divisions/ticks.
Counter Displays SMPTE timecode or bars/beats/divisions/ticks.
SELECT ASSIGN Displays the Encoder assignment as follows: Pan, Snd1 to Snd8, S1As to
S8As, In, Out.