Daim Ntawv Qhia Tus Neeg Siv

19Control Surfaces Support Guide for Logic Pro
Control Action
V-Pot 7 or F6 Switches to Surround Angle/Diversity Mixer view.
• The mode display shows “Ad” (Angle/Diversity).
• The upper LCD row shows channel strip names.
• The lower LCD row shows the surround angle currently assigned to
each channel strip.
• Rotating a V-Pot changes the surround angle (or adjusts pan position
on non-surround channel strips).
• Pressing a V-Pot sets the surround angle to its default value.
• The faders edit surround diversity.
V-Pot 8 or F7 Switches to Surround X/Y Mixer view.
• The mode display shows “XY.”
• The upper LCD row shows channel strip names.
• The lower LCD row shows the surround X value currently assigned to
each channel strip.
• Rotating a V-Pot changes the surround X value (or adjusts pan position
on non-surround channel strips).
• Pressing a V-Pot sets surround X to its default value.
• The faders edit surround Y.
Note:The X and Y parameters are limited to a rectangular coordinate system. As such,
value pairs outside the surround circle are not possible. If you try to set a Y value that
is invalid, the X coordinate is automatically adjusted to a valid position, and vice versa.
For example, moving Y to +1000 results in an X coordinate value of 0. When only one
coordinate value is edited, the other coordinate value defaults to the setting of the most
recently selected channel strip. This helps you to create linear movements. X and Y have
a value range of –1000 to +1000, but the resolution is not that high because surround
positions are currently recorded as 7-bit data.
MackieControl EQ button
MackieControl EQ button in Logic Pro
Press the EQ button to activate
EQ Mixer view.
Press the EQ button repeatedly to switch between EQ Mixer view and EQ Channel view.
Hold down the EQ button to access the Options in EQ edit mode submenu in the LCD.
Note:If no Channel or Linear Phase EQ is present on the selected channel strip, a Channel
EQ is inserted automatically when you enter EQ Channel view.
Mackie Control EQ Mixer view in Logic Pro
EQ Mixer view allows you to edit one equalizer parameter for all channel strips: Frequency,
Gain, Q, or EQ bypass. The EQ band number, and parameter being edited, are displayed
briefly when you switch to this mode.
• The mode display shows E1 to E8, indicating the selected EQ band.
• The upper LCD row shows channel strip names.
• Rotating the V-Pots changes the current EQ parameter.