Daim Ntawv Qhia Tus Neeg Siv

174Control Surfaces Support Guide for Logic Pro
Control Assignment
Encoder 19 (Q 3) Controls the Q factor of band 7, if a Channel or Linear Phase EQ is
inserted.
Encoder 20 (GAIN 4) Controls the Slope parameter of band 8, if a Channel or Linear Phase EQ
is inserted.
Encoder 21 (FREQ 4) Controls the Frequency parameter of band 8, if a Channel or Linear Phase
EQ is inserted.
Encoder 22 (Q 4) Controls the Q factor of band 8, if a Channel or Linear Phase EQ is
inserted.
Encoder 24 (PAN) Controls Pan/Balance (of mono or stereo channels).
Tascam US-2400 master channel in Logic Pro
The table outlines the master channel strip controls and their assignments.
Control Assignment
SEL Selects Master Output channel strip
if it exists; if not, Output channel
1–2 is selected.
CLR SOLO Disables Solo for all tracks/
channels.
SHIFT Disables Mute for all tracks/
channels.
F-KEY Disables the Record Enable buttons
of all tracks/channels.
FLIP Switches Flip mode between Off
(LED off) and Duplicate (LED on).
In this mode, the fader of each
channel strip mirrors the encoder
function.
SHIFT Sets Flip mode to Swap (LED
flashing). In this mode, the
parameters controlled by the fader
and encoder are swapped.
F-KEY Sets Flip mode to Zero—fader
motors are disabled (LED flashing).