Daim Ntawv Qhia Tus Neeg Siv

170Control Surfaces Support Guide for Logic Pro
TascamUS-2400
Set up your Tascam US-2400 in Logic Pro
The US-2400 is capable of running in both native and MackieControl emulation modes.
If the unit is set up in MackieControl emulation mode, and the native support plug-in is
installed in the Logic Pro program bundle, Logic Pro detects a US-2400 native control
surface and a MackieControl, plus two Extender (XT) units.
To run the US-2400 in MackieControl mode, remove the US-2400 plug-in from the Logic
Pro application bundle. Logic Pro will then detect a MackieControl plus two Extender (XT)
units (the appropriate setup for the US-2400 in MackieControl emulation mode) when you
scan for control surfaces.
The button layout of the MackieControl differs from that of the TascamUS-2400.
When running the TascamUS-2400 in MackieControl mode, certain controllers are not
accessible (the Joystick, for example). Given these restrictions, use of the TascamUS-
2400 in MackieControl mode is not recommended. If you choose to do so, refer to the
documentation supplied with the TascamUS-2400 for details.
Follow the steps below to use your TascamUS-2400 with Logic Pro.
Set up the TascamUS-2400 for use with Logic Pro
1. Make sure that your US-2400 control surfaces are connected to the computer via USB.
2. Ensure that the US-2400 is in native mode. Consult your US-2400 manual for more
information on this setting.
3. Open Logic Pro.
Your control surfaces are scanned for, and installed, automatically.