Daim Ntawv Qhia Tus Neeg Siv

155Control Surfaces Support Guide for Logic Pro
Control Modifier Assignment
Faders 1 to 8 Controls volume, or duplicates the
parameter assigned to the encoder
above (if Flip mode is enabled).
Master Fader Controls the Master Level fader if
it exists; if not, controls Output 1–2
level.
EQ button Inserts a Channel EQ in the channel
if no Channel or Linear Phase EQ is
present.
Radikal Technologies SAC-2K Mixer view controls
in Logic Pro
The table outlines the Mixer view controls and their assignments.
Note:A modifier button, such as SHIFT, below a button description indicates that the
button has an alternate use while the modifier is held down.
Control Modifier Assignment
Pan Switches to Mixer view
(multichannel) pan editing.Encoders
9 to 12 edit Pan/Angle, Diversity,
LFE, and Spread of selected channel
(in Surround mode).
High, HiMid, LowMid, Low Switches to Mixer view
(multichannel) gain editing of a
certain EQ band. Encoders 9 to 12
edit Frequency, Gain, Q factor, and
On/Off for the selected channel.
Pressing and releasing the button
chooses a specific EQ band. While
held down, you can use Encoder
9 to choose the EQ band that you
want to edit (bands 1 to 8). The
button’s LED is lit when in Mixer
view Gain Editing mode (of the
selected channel EQ band).
• Low: Band 3 (first parametric EQ
band)
• LowMid: Band 4 (second
parametric EQ band)
• HiMid: Band 5 (third parametric
EQ band)
• High: Band 6 (fourth parametric
EQ band)
Snd/Ins Switches the four Snd/Ins (1 to 4)
buttons between Send and Insert
modes.
• LED off: Send mode
• LED on: Insert mode