Daim Ntawv Qhia Tus Neeg Siv

150Control Surfaces Support Guide for Logic Pro
Start a focused scene: Deselect all cells in the grid, then press the Scene button under the
Stop column.
Record to an empty cell: Select an empty cell, then press the Scene button under the
Stop column.
Change send levels
You can use Launchpad devices to set send levels to varying degrees, depending on
device. When you first enter Mixer mode, the pads for tracks using the first two sends are
lit. The brightness of the pads corresponds to the send level. You can quickly set the send
levels to 0 dB for each track.
On the Launchpad MK2, Launchpad X, and Launchpad Mini MK3 you can set levels
more precisely for the first two sends on each track. The columns Send A and Send B
correspond to Send 1 and Send 2 in Logic Pro, respectively.
On the Launchpad Pro you can set levels for Sends 1–8. Instead of using Mixer mode, push
the Sends button to jump directly to Send mode.
Send mode
In Send mode, the pads are lit in rows representing the send level for each track. The Send
level bar is shown from left to right. Pressing a pad changes the send level of the track to
the level corresponding to the pressed pad.
Launchpad MK2, Launchpad Mini MK3, Launchpad X: If Send 1 is selected, the Send A
button is lit. If Send 2 is selected, the Send B button is lit.
Launchpad Pro only: The eight scene buttons correspond to Sends 1–8.
Do any of the following:
• Set the send level to 0 dB: Press Mixer to enter Mixer mode, then press the pad in the
Send column (A or B) that represents the track and send levels you want to change.
• Raise or lower the send level:
• Launchpad MK2, Launchpad X, and Launchpad Mini MK3: In Mixer mode, press the
Send A or Send B Scene buttons to enter Send mode.
Launchpad Pro: Press the Sends mixer button to enter Send mode, then press the
corresponding Scene button for sends 1–8.
• In the row for the corresponding track, move your finger horizontally across the pads
to change the send level.
• Press the Mixer button to return to Mixer mode, or press the Session button to return
to Session mode.
Launchpad X and Launchpad Mini MK3: Press the active Send mode button again to
return to Session/Mixer mode, or press the Session button to return to Session mode.
Launchpad Pro: Press the Sends mixer button again to exit Send mode and return to
Session mode.
Launchpad Pro and Launchpad X only: You can control how fast the send level changes
by pressing the pads harder or more lightly. The harder you press, the faster the send
level changes.