Daim Ntawv Qhia Tus Neeg Siv

125Control Surfaces Support Guide for Logic Pro
Mackie HUI status/group controls in Logic Pro
The table outlines the status/group controls and their assignments.
Note:A modifier button, such as SHIFT, below a button description indicates that the
button has an alternate use while the modifier is held down.
Control Modifier Assignment
AUTO While held down, the scribble strips
display the automation mode of all
channels.
MONITOR —
PHASE—SHIFT Switches to Single view.
GROUP Enters Group Edit mode:
• The upper line (in the DSPEdit
section) displays the number and
name of the group being edited.
• DSPSelect buttons 1 to 4 switch
between the properties of the
group being edited. The group
name is shown in the lower line.
• When the INSERT/PARAM button
is off, the DSPEdit V-Pots scroll
through the group properties. If
the INSERT/PARAM button is on,
the DSPEDIT V-Pots select the
group that you want to edit.
• The SELECT buttons enable/
disable group membership of the
channel.
SHIFT/ADD Switches to Channel view.
CREATE Creates a new group and enters
Group Edit mode (see above).
SHIFT/ADD Switches to Mixer view.
SUSPEND Activates or deactivates the Group
Clutch.
SHIFT/ADD Switches to Tracks view.