Daim Ntawv Qhia Tus Neeg Siv

120Control Surfaces Support Guide for Logic Pro
Mackie HUI channel strips in Logic Pro
The table outlines the channel strip controls and their assignments.
Note:A modifier button, such as SHIFT, below a button description indicates that the
button has an alternate use while the modifier is held down.
Control Modifier Assignment
Level meters Displays momentary and peak
levels.
REC/RDY Activates or deactivates the Record
Enable button.
OPTION/ALL Disables the Record Enable buttons
of all channel strips.
INSERT
• BYPASS button OFF (see Insert
Select mode in
HUI assign
controls
): selects channel strip
for plug-in selection.
• BYPASS button ON: Enables or
disables bypass of currently
selected Insert slot.
V-SEL
• PAN button ON: sets Pan
parameter to center position if
DEFAULT button is on.
• Send 1 to 8 selected: edits Send
Pre/Post, turns Send Mute on or
off, or sets Send Level to default
value.
• In Send Destination Assignment
mode, Channel Strip Input or
Channel Strip Output Assignment
mode: the V-SEL buttons confirm
your selection.
V-Pot Adjusts parameter selected in the
ASSIGN section.
AUTO Cycles through automation modes.
If you hold down an automation
mode button, pressing AUTO sets
this mode.
SOLO Enables or disables the Solo button.
OPTION/ALL Disables the Solo buttons of all
channel strips.
MUTE Enables or disables the Mute
button.
OPTION/ALL Disables the Mute buttons of all
channel strips.
Scribble strip Displays the channel strip name or
send, input, or output assignment.
SELECT Selects the channel strip.
SHIFT/ADD Sets volume to unity level.