Owner's manual

MAINTENANCE WORK ON CHASSIS AND ENGINE 132
100160-10
– Remove the screw from the rear of the flasher housing.
– Tilt headlamp diffuser  forward carefully and take it off.
– Press the flasher bulb carefully into the socket, turn it counterclockwise by about 30°,
and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
– Press the new flasher bulb carefully into the socket and turn it clockwise until it stops.
Flasher light (RY10W / socket BAU15s) ( p. 173)
– Position the diffuser.
– Insert the screw and turn it counterclockwise first until it engages in the thread. Tighten
the screw slightly.
– Check the flasher system function.
9.67Checking the headlight setting
0
0
AA
0
0
BB
400726-10
– Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
– Make another mark at a distance  under the first mark.
Guideline
Distance  5 cm (2 in)
– Position the vehicle vertically at a distance  in front of the wall.
Guideline
Distance  5 m (16 ft)
– Check the headlight setting.