Owner's manual

MAINTENANCE WORK ON CHASSIS AND ENGINE 117
100277-10
– Disconnect the negative (minus) cable of the battery.
– Pull off the plug connector  upwards.
– Remove screws .
– Pull the retaining bracket  of the battery forward and remove it.
– Take off the positive pole cover .
– Disconnect the positive (plus) cable of the battery.
– Push the wiring harness to the side and pull the battery out of the battery rack.
Info
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components and safety devices can be damaged. The vehi-
cle is therefore no longer roadworthy.
9.56Installing the battery x
100277-11
– Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
– Attach the positive cable and mount positive terminal cover .
– Position retaining bracket .
– Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Plug in connector .
– Attach the minus cable .
– Mount the seat. ( p. 116)