Operation Manual

15 ELECTRICAL SYSTEM 96
E00358-10
Main work
–
Turn protection cap

together with the underlying bulb socket counterclockwise
all the way and remove it.
–
Pull bulb socket

of the parking light out of the reflector.
E00359-10
–
Pull out headlight bulb

.
– Insert the new headlight bulb.
Headlight (HS1/socket BX43t) ( p. 127)
– Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that O-ring

is seated properly.
– Insert the bulb socket of the parking light into the reflector.
Finishing work
– Install the headlight mask with the headlight. ( p. 95)
– Check the headlight setting. ( p. 97)
15.8 Changing the turn signal bulb (All EXC/EXC Six Days models)
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
E00360-10
Main work
– Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass

.
–
Lightly squeeze orange cap

in the area of the holding lugs and take it off.
– Press the turn signal bulb lightly into the socket, turn it counterclockwise by about
30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it free from grease.
– Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) ( p. 127)
– Mount the orange cap.
– Position the turn signal glass.
– Insert the screw and first turn counterclockwise until it engages in the thread with
a small jerk. Tighten the screw lightly.
Finishing work
– Check that the turn signal system is functioning properly.