Operation Manual

12 SERVICE WORK ON THE CHASSIS 75
E00339-10
–
Now inject the fluid into the system until it emerges from drill hole

of the mas-
ter cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
– Remove the bleeding syringe. Mount and tighten screws bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim 4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilled brake fluid immediately with water.
12.46 Removing the engine guard (All Six Days models, EXC AU)
H01638-10
–
Remove screws

and engine guard.
12.47 Installing the engine guard (All Six Days models, EXC AU)
H01638-10
– Attach the engine guard on the frame at the rear and swing up at the front.
–
Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)