Operation Manual

12 SERVICE WORK ON THE CHASSIS 56
V00338-10
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 20 Nm
(14.8 lbf ft)
–
Tighten screws

.
Guideline
Screw, bottom triple clamp M8 15 Nm
(11.1 lbf ft)
V00337-10
–
Tighten screw

.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
V00337-11
–
Tighten screw

.
Guideline
Screw, top steering stem M8 20 Nm
(14.8 lbf ft)
E00375-12
–
Position the brake caliper, and mount and tighten screws

.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite
®
243™
– Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws

.
Finishing work
– Mount the handlebar cushion.
– Install the front fender. ( p. 60)
– Install the front wheel. ( p. 85)
– Install the headlight mask with the headlight. ( p. 95)
– Check that the wiring harness, throttle cables, and brake and clutch lines can move
freely and are routed correctly.
– Check the play of the steering head bearing. ( p. 58)
– Remove the motorcycle from the lift stand. ( p. 51)
– Check the headlight setting. ( p. 97)