Operation Manual

11 TUNING THE CHASSIS 49
M00987-10
(All Six Days models)
On the upper triple clamp, there are 2 holes at a distance of

to each other.
Hole distance A 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of

from the center.
Hole distance B 3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This allows the handle-
bar to be mounted in the most comfortable position for the rider.
11.16 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
– Change the handlebar if the handlebar is damaged or bent.
M00993-11
(All standard EXC/XC-W models)
–
Remove screws

. Take off the handlebar clamps. Remove the handlebar and
lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws

. Take off the handlebar supports.
– Place the handlebar supports in the required position. Mount and tighten
screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
– Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws

and tighten evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap widths are even.