Installation guide

-8-
1.3 Hardware Specifications
Standard Compliance: IEEE802.3/802.3ab / 802.3z / 802.3u / 802.3x
Network Interface:
Configuration Mode Connector Port
10/100/1000Mbps Gigabit Copper NWay RJ-45 1 - 24
1000Base-X Gigabit Fiber 1000 FDX SFP* 23,24(Option)
*Port 23, 24 are RJ-45/SFP fiber dual media ports with auto detected function.
*Optional SFP modules support MMF, SMF LC or BiDi LC transceiver.
Transmission Mode: 10/100Mbps support full or half duplex, 1000Mbps support full duplex only
Transmission Speed: 10/100/1000Mbps for Gigabit copper ports, 1000Mbps for Gigabit Fiber ports
Full Forwarding Packet Rate: PPS (packets per second)
Forwarding Rate Speed
1,488,000pps 1000Mbps
148,800pps 100Mbps
14,880pps 10Mbps
MAC Address and Self-learning: 8K MAC address
VLAN Table: 4K VLAN table entries
Buffer Memory: Embedded 400 KB frame buffer
Flow Control:
IEEE802.3x compliant for full duplex
Backpressure flow control for half duplex
Cable and Maximum Length:
Gigabit copper Cat. 5 UTP cable Cat.5e recommended, up to 100m
Gigabit fiber 50/125, 60/125 MMF, 9/125 SMF, distance (depending on the SFP transceiver)
Diagnostic LED:
System LED : Power
Port 1 - 24 10/100/1000M : Speed status
Port 1 - 24 LINK/ACT : Link status and activities
Port 23, 24 SFP : SFP fiber link status
Power Requirement: Voltage 100 - 240 VAC, Frequency 50/60 Hz, Consumption 30W
Ambient Temperature: Operating 0 to 50
o
C, Humidity 5% to 90%
Dimensions: 44(H) ( 442(W) ( 209(D) mm
Approval: Comply with FCC Part 15 Class A & CE Mark Approval