Installation guide

-30-
3.2.10 Trap Event Configuration
The Trap Events Configuration function is used to enable the switch to send out the SNMP trap
information while predefined trap events occurred.
Parameter description:
Trap IP: IP address of the SNMP trap manager who can receive the traps. Two trap managers
are supported.
System Events:
Warm Boot Warm Start Management operation event
Cold Boot Power on event of the switch
Illegal Login Invalid login event
Port Events:
Link Up Port link up event
Link Down Port link down event
Rx error threshold Rx error over threshold event
Tx error threshold Tx error over threshold event
Error threshold The number of error packets in 5 seconds
This page also displays occurrence counters of some events.