Instruction manual

-67-
Button Description
Apply Button to save the configuration
Recover Button to release blocked switches and failed section after network fault
repairing
Note : it may not recover the whole failed section by just one click
especially in the case when multiple faults occur at the same time.
Click and use [Ring List] button to display ring status until the
recovery is complete.
Standby Button to instruct all ring members enters into standby state (on guard) for
fault monitoring after ring list shows everything is back to normal
Inactive Button to relieve the backup port function of the master switch
5.4.6 WDT Controls
The switch provides WDT (Watch Dog Timer) function. If enabled,
A watchdog timer is a hardware timing circuit that triggers a system reset if the switch firmware, due
to some fault condition, such as a hang, neglects to regularly service the watchdog. The intention is to
bring the system back from the hung state into normal operation.
Setting Description
WDT Function Setting Enable or disable WDT function
WDT Time Setting (1~60sec) Watch Dog timer configuration