User`s manual

-30-
Configuration Function
Auto-Negotiation Enable – enable auto-negotiation
Disable – disable auto-negotiation
Speed 100M – Fast Ethernet 100Mbps
10M – Ethernet 10Mbps
1000M – Gigabit Ethernet 1000Mbps
Duplex Full – Full duplex
Half – Half duplex
Pause Enable – enable 802.3x pause flow control
Disable – disable 802.3x pause flow control
Backpressure Enable – enable Backpressure flow control
Disable – disable Backpressure flow control
Addr. Learning Enable – enable port auto address learning
Disable – disable port auto address learning
Select Port No. v - Select the port numbers to use the above port configuration settings.
[Apply] Click to apply the configuration change
Current Status Function
Link Down – port link down
100FDX – 100M Full duplex
100HDX – 100M Half duplex
10FDX – 10M Full duplex
10HDX – 10M Half duplex
1000FDX – 1000M Full duplex
1000HDX – 1000M Half duplex
FlowCtrl ON – Flow control enabled
OFF – Flow control disabled
Note:
1. 802.3x pause flow control is used for full duplex mode.
2. Backpressure flow control is used for half duplex mode.