User`s manual

-22-
P25 & P26
LINK/Act Port link status ON P25 & P26 copper port link is established. (No traffic)
(Green) BLINK Port link is up and there is traffic.
OFF Port link is down.
1000M Port speed status ON P25 & P26 copper port 1000Mbps is selected.
(Yellow) OFF P25 & P26 copper port 10 or 100Mbps is selected.
F25 LINK Port link status ON P25 SFP fiber link is established.
OFF Port link is down.
F26 LINK Port link status ON P26 SFP fiber link is established.
OFF Port link is down.
3.4 Configuring IP Address and Password for the Switch
The switch is shipped with the following factory default settings for software management:
Default IP address of the switch: 192.168.0.2 / 255.255.255.0
The IP Address is an identification of the switch in a TCP/IP network. Each switch should be designated a new
and unique IP address in the network. Refer to Web management interface for System Configuration.
The switch is shipped with factory default password 123 for software management.
The password is used for authentication in accessing to the switch via Http web-based interface. For security
reason, it is recommended to change the default settings for the switch before deploying it to your network.
Refer to Web management interface for System Configuration.