Installation guide

-9-
Configuration Setting Switches (SW)
NO. FUNCTION SETTINGS
SW1 TP Port mode OFF Auto-negotiation (default)
ON Forced mode
SW2 TP Port Duplex OFF Full duplex (default)
ON Half duplex
SW3 TP Port Speed OFF 100Mbps (default)
ON 10Mbps
SW4 Link Fault Pass Through OFF Enable (default)
ON Disable
SW5 Forwarding mode OFF Store-and-forward alwayes (default)
ON Smart-forward mode
SW6 802.3x function OFF Enable (default)
ON Disable
SW7 FX port duplex OFF Full duplex mode (default)
ON Half duplex mode
LED Indicators
LED DISPLAY STATE INTERPRETATION
PWR Power status ON Power on
OFF Power off
TP LINK TP port link status ON Link up and no traffic
OFF Link fault
BLINK Rx/Tx activities
TP 100M TP port speed status ON 100Mbps
OFF 10Mbps
TP FDX TP port duplex status ON Full duplex
OFF Half duplex
BLINK Collisions on half duplex
FX LINK FX port link status ON Link up and no traffic
OFF Link fault
BLINK Rx/Tx activities
FX OL FX port optical link ON Optical signal is detected
OFF No optical signal