Installation guide

-26-
3.1 Configuration Switches
SW FUNCTION SETTING & STATE
SW1 TP Port mode OFF Auto-negotiation (default)
ON Forced mode
SW2 TP Port Duplex OFF Full duplex (default)
ON Half duplex
SW3 TP Port Speed OFF 100Mbps (default)
ON 10Mbps
SW4 Link Fault Pass Through OFF Enable (default)
ON Disable
SW5 Forwarding mode OFF Store-and-forward always (default)
ON Smart-forward mode
SW6 802.3x function OFF Enable (default)
ON Disable
SW7 FX port duplex OFF Full duplex mode (default)
ON Half duplex mode
SW8 Reserved
Note:
1. SW1, SW2, SW3 are used for configuring the TP port especially
when connecting to a link partner port which is not auto-negotia-
tion capable. Refer to section 2.5 for details.
2. SW4 is used to enable or disable Link Fault Pass Through func-
tion. Refer to section 1.4 for details about Link Fault Pass Through
function. Also note that the LED display has different indication
when the function is enabled and disabled.