Installation guide

-15-
2.4 Making TP Port Connection
TP port is featured to support connection to :
Auto-negotiation devices
Auto-negotiation incapable 10BASE-T devices
Auto-negotiation incapable 100BASE-TX devices
Network Cables
10BASE-T: 2-pair UTP Cat. 3,4,5 , EIA/TIA- 568 100-ohm STP
100BASE-TX: 2-pair UTP Cat. 5, EIA/TIA-568 100-ohm STP
Link distance: Up to 100 meters
Configuration Setup
To make a proper connection, the following configuration settings are
recommended:
TP port link partner SW1 SW2 SW3
Auto-negotiation device Off: auto Off: full duplex Off: 100M
Fixed 10M half duplex device On: forced On: half duplex On: 10M
Fixed 100M half duplex device On: forced On: half duplex Off: 100M
Fixed 10M full duplex device On: forced Off: full duplex On: 10M
Fixed 100M full duplex device On: forced Off: full duplex Off: 100M