Installation guide

-20-
2.7 Reset Button
The reset button is used to perform a hardware reset to the switch. It is not used in normal cases and
can be used for diagnostic purpose. If any network hanging problem is suspected, it is useful to push the
button to reset the switch without turning off the power. Check whether the network is recovered.
2.8 Selecting UTP or Fiber
If the switch is equipped with FX7 port or FX8 port, it is required to select the media type to be used for
the switched Port 7 and Port 8. Set the setting SW which is located on bottom panel to make the
selection.
Model SW ON Position OFF Position
800 SW1 - Reserved
SW2 - Reserved
800-1 SW1 - Reserved
SW2 Select FX8 Select 10/100TX RJ-45 TP8
800-2 SW1 Select FX7 Select 10/100TX RJ-45 TP7
SW2 Select FX8 Select 10/100TX RJ-45 TP8
Note: Do not change the reserved states specified in the above table.