User's Manual

■Tone Scanning
Scanning for DCS and CTCSS Codes/ Tones
Scanning for a DCS code or CTCSS tone can be done while Frequency Mode (VFO) or Channel Mode (MR) is
selected. Only when VFO mode is selected, can the detected code / tone be saved to menu 11/12.
NOTE
DCS code and CTCSS tone scanning mode can be accessed with or without a signal being present. The scanning
process itself only occurs while a signal is being received.
Not all repeaters requiring a DCS code or CTCSS tone for access will transmit one back. In that case, the
transmitter of a station that can access the repeater would need to be scanned. In other words: this would be
done by listening to stations on the repeater's input frequency.
Scanning for a DCS Tone
1. Press [MENU] key to enter the menu.
2. Enter [1][1]on your numeric keypad to come to Menu 11: RX DCS.
3. Press the [MENU] key to select. Insure you have a tone activated (and it is not off).
4. Press the [* ] to begin DCS scanning.