User's Manual

3.2 Scanning
The radio features a built in scanner for the VHF and UHF bands. When in Frequency (VFO) mode it will scan in
steps according to your set frequency step. In Channel (MR) mode it will scan your channels.
Dual Watch is inhibited while scanning
NOTE
To enable the scanner, press and hold the [* ] key for about two seconds. Press [# ] key to exit scanning
mode.
■Scanning modes
The scanner is configurable to one of three ways of operation: Time, carrier or search, each of which is
explained in further details in their respective section below.
Procedure 3.2.1 Setting scanner mode
1. Press the [MENU] key to enter the menu.
2. Enter [1][8] on your numeric keypad to come to scanner mode.
3. Press the [MENU] key to select.
4. Use the [UP] and [DOWN] keys to select scanning mode.