Users Manual Part 1
28 US-EN
Cleaning and storage
Set the power button
9
to position “O“ before
cleaning the product.
Unplug the power cable
4
from the outlet
before cleaning the product.
Do not rinse the product directly with water.
Do not wipe the product with a soaking cloth.
Disconnect the power supply if the product will
not be used for an extended period.
Part Cleaning intervals
Dust bin
17
Varies by use
Primary, HEPA
filter
6
Weekly, 2 x weekly if very
dirty
Side brushes
20
Every 4 weeks
Combo floor
brush
19
Weekly, 2 x weekly if very dirty
Cliff sensors
21
Every 2 weeks
Front wheel
22
Every 4 weeks
Cleaning the dust bin and filter
Hold the “Dust bin“ button
11
und pull the dust
bin
17
out of the product.
Open the dust bin
17
by pushing the tab and
open the cover
24
upwards.
You can now empty the contents into a
garbage can.
Then first remove the main filter
25
. It has two
tabs to pull it out.
Remove the HEPA filter
6
and the foam filter
26
together by pulling the HEPA filter
6
out by
the tab.
Y
ou can now clean the dust bin
17
and the
main
filter
25
with water.
The HEPA filter
6
and the foam filter
26
can
be tapped to clean them. Do not wash these
with water.
Reinstall the filters
6
,
25
,
26
and the dust bin
17
in the reverse order.
Please note, all parts must be completely dry
before installing them.
Cleaning the dust bin
Remove and empty the dust bin
17
.
Remove the filters
6
,
25
,
26
. The HEPA filter
6
can be tapped to clean. Do not wash with water.
Rinse the dust bin
17
and the main filter
25
.
Cleaning the brushes
Remove the combo floor brush
19
and remove
any hair or dirt.
Remove the side brushes
20
and remove any
hair or dirt.
Cleaning the main housing
Clean the front wheel
22
to remove any hair
tangled in it.
Clean the 3 cliff sensors
21
to maintain their
sensitivity.
Clean the anti-collision sensor
23
to maintain
its sensitivity.
Cleaning the charging dock
Clean the charging contacts
3
on the bottom
of the robot vacuum cleaner and the charging
dock with a dry cloth.
Troubleshooting
If the product is not working correctly, the display
1
will show various error codes and emit different
length beeps. Please refer to the table below for
troubleshooting:
309029_1901__silv_Saugroboter SSRA1_content_US.indd 28 11.09.19 08:26