Audio System S7 User Manual BLUETOOTH 3” WEATHER RATED SPEAKER AND AMPLIFIER SYSTEM
S7S7 Motorcycle Motorcycle Loudspeaker Loudspeaker Amplification Amplification System System 1.Features: 5.0 Bluetooth Audio 3.0 USB FM radio Aluminum alloy shell 2.
S7 Motorcycle Loudspeaker Amplification System 3.Wiring: Step 1 : The red end of the power cord is connected to the positive pole of the battery, the black end of the power cord is connected to the negative pole of the battery, and then connect the power cord to the host.(Fig ①) Step 2 : Plug the speaker connector of the main speaker to the slave speaker. (Fig ②) Note: Please remember the two arrows on each connectors should be on one line.
S7 Motorcycle Loudspeaker Amplification System 4.Operating Instructions PWR knob Powre On/Off Volume adjustment Pause/Mute MODE knob Mode conversion Up and down songs/ up and down stations 4.1. PWR knob 4.1.1.Press the knob for a short time to turn on, and press and hold for about 2 seconds to turn off. 4.1.2.In the radio mode, press the knob shortly to mute, and then press the knob shortly to release the mute. 4.1.3.
S7 Motorcycle Loudspeaker Amplification System 4.3.USB Music Mode After inserting the USB, MP3/FLAC/AWV audio songs will be played automatically. Note: USB mode can only be switched when an external USB source is connected. 5.Bluetooth Connection To pair and connect your bluetooth device to the S7,enter the MOD knob until you hear the voice prompt "Bluetooth mode", which means that it has turned to Bluetooth mode. At this time, you can use your bluetooth device to connect with Bluetooth.
S7 Motorcycle Loudspeaker Amplification System Main Speaker Spring washer Upper Bracket M8×30 Screw Lower Bracket Mount each speaker with its clamp to the handlebar of the motorcycle . Note : Different size handlebar please insert different slot of the bracket as below . For 7/8" and 1 "Handlebars For 1.
S7 Motorcycle Loudspeaker Amplification System 7.Technical Parameters Radio frequency range-------------------------------------------87.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
