User's Guide

13
chiliPAD care
maintaining your sleep system
WATER MAINTENANCE
Once per month add one packet of chiliPAD System Cleaner following the instructions below.
This cleaner can be purchased at chilitechnology.com
1. Using the drain key, empty the water in the Control Unit’s reservoir.
2. Refill with water and add in the chiliPAD System Cleaner. IT IS IMPORTANT THAT YOU
LEAVE THE RESERVOIR CAP OFF.
3. Ensure the Control Unit is connected to the Hydronic Pad and run the Control Unit on “HI”
for 1 hour.
4. Drain the water mixture from the Control Unit and refill with distilled water.
CLEAN THE EXTERIOR OF THE CONTROL UNIT
With the Control Unit turned off and unplugged, use a clean damp cloth to clean the outside of the
Control Unit and remote control. Be careful not to get water inside of the Control Unit.
Use can of compressed air to blow through the intake/exhaust vents on all sides removing dust and
debris. Never submerge or get water inside the Control Unit.
WASH THE HYDRONIC PAD AS NEEDED
Wash the Hydronic Pad using a front-loading washing machine with cold water on a gentle/deli-
cate cycle. Secure the connection tubes with the attached Wash Strap to minimize risk of it flailing
in the spin cycle and damaging the connector.
DO NOT BLEACH, DO NOT IRON, DO NOT DRY-CLEAN
TUMBLE DRY ON LOW
No Heat/Air
Delicate/
Gentle
Do Not Iron
Do Not Bleach
Do Not
Dryclean
Delicate/
Gentle