SDS
Section 2. Hazards identification
Precautionary statements
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Use personal protective equipment as required. Wear
protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces,
sparks, open flames and other ignition sources. No smoking. Pressurized container: Do
not pierce or burn, even after use. Do not spray on an open flame or other ignition
source. Use only outdoors or in a well-ventilated area. Do not breathe dust or mist.
Wash hands thoroughly after handling.
Response
:
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF INHALED: Remove victim to fresh air and keep at rest in a position
comfortable for breathing. Call a POISON CENTER or physician if you feel unwell. IF
SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce
vomiting. IF ON SKIN: Wash with plenty of soap and water. Take off contaminated
clothing. Wash contaminated clothing before reuse. If skin irritation occurs: Get
medical attention. IF IN EYES: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation
persists: Get medical attention.
Storage
:
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50
°C/122 °F. Store in a well-ventilated place.
Disposal
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
General
:
Read label before use. Keep out of reach of children. If medical advice is needed, have
product container or label at hand.
Hazards not otherwise
classified
:
None known.
Extremely flammable aerosol.
Contains gas under pressure; may explode if heated.
Causes skin and eye irritation.
May cause cancer.
Suspected of damaging fertility or the unborn child.
May be fatal if swallowed and enters airways.
May cause respiratory irritation.
May cause drowsiness and dizziness.
May cause damage to organs through prolonged or repeated exposure.
:
Hazard statements
Please refer to the SDS for additional information. Keep upright in a cool, dry place. Do
not discard empty can in trash compactor.
Supplemental label
elements
Adequate ventilation required when sanding or abrading the dried film. If Adequate
ventilation cannot be provided wear an approved particulate respirator (NIOSH
approved). Follow respirator manufacturer's directions for respirator use. DELAYED
EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of the dry film
may release crystalline silica which has been shown to cause lung damage and cancer
under long term exposure. DANGER: Rags, steel wool, other waste soaked with this
product, and sanding residue may spontaneously catch fire if improperly discarded.
Immediately place rags, steel wool, other waste soaked with this product, and sanding
residue in a sealed, water-filled, metal container. Dispose of in accordance with local fire
regulations. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains
solvents which can cause permanent brain and nervous system damage. Intentional
misuse by deliberately concentrating and inhaling the contents can be harmful or fatal.
WARNING: This product contains chemicals known to the State of California to cause
cancer and birth defects or other reproductive harm.
Date of issue/Date of revision
:
5/4/2015.
Date of previous issue
:
3/13/2015.
Version
:
1.01
2/16