Operation Manual

11
• Once you have obtained the desired
quantity of frothy milk, turn the selector (c)
to the O setting.
• After use, remove the flexible tube (l4) from
the container and clean the auto cappuccino
accessory (see section “Cleaning the
Machine”).
. HEATING WATER (FOR TEA, FOR EXAMPLE) OR
THICK
LIQUIDS (SOUP, FOR EXAMPLE)
The steam function together with the steam
nozzle (h) make it easy to heat water for a
variety of instant foods and beverages.
. Mounting of the steam nozzle (h) :
• Move the auto cappuccino accessory (l) to
the exterior of the appliance and unscrew
his ring (l1).
• Mount the steam nozzle (h) in place of the
auto cappuccino accessory (l).
• Screw the ring (h3) of the steam nozzle. Be
careful to the seal.
• Move the steam nozzle to the interior of the
appliance.
Please note: the sliding part (h2) of the
nozzle must be in the raised position (6).
• Fill the water tank and set the switch (d) to
«I». The indicator light (d1) comes on.
• Turn the function selector (c) to the position
«
».
• Move the nozzle towards the outside of the
appliance.
As soon as the appliance reaches the
appropriate temperature, the temperature
control indicator light (e) will come on.
• Immerse the tip of the nozzle in the liquid to
be heated (7). Return the nozzle to the
inside and hold the container by its handle
or place it on the grid (i) (7).
• Then turn the function selector (c) to the
position «
» until the liquid is hot enough,
then reset it to the position O and remove
the container.
• For liquids other than water, turn the
function selector (c) to the position «
» for
the cleaning operation in order to prevent
the nozzle from becoming blocked:
. place an empty container under the nozzle.
. select the position «
» again.
. turn the function selector (c) to the position
O.
. clean the nozzle with a damp cloth.
• For thorough cleaning of the nozzle, please
refer to the paragraph «Maintenance».
Notes
If you wish to make an espresso immediately
after steam, the appliance must first cool
down until it reaches the right temperature
for extraction.
• To do this, insert an empty filter holder (no
coffee) in the machine and position a
suitable container beneath it. Then turn the
function selector (c) to the position «
».
• Let the water run through until the indicator
light (e) goes out. Then, turn the function
selector (c) to the position O.
After this, the machine is now ready once
more to make an espresso (see paragraph
«espresso function»).
Please note: when the appliance is running,
and also afterwards, the nozzle will be very
hot. Allow time for the appliance to cool
down to prevent scalding or burning.
Maintenance
• Unplug the appliance and allow it to cool.
• Never wash the accessories for your espresso
in the dishwasher.
• Clean the body of the appliance with a
damp cloth.
After use, the water tank must be emptied.
. The drip tray (j)
• Each time an espresso is prepared, the drip
tray fills with water. This is perfectly normal.
To prevent any overflow, remove the grid (8)
and empty the drip tray regularly.
• If necessary, clean the drip tray and the grid
with water and a little non-abrasive
washing-up liquid, rinse and dry. When
replacing, return the plastic block situated at
the back of the tray (9).