Operation Manual

EN
35
MALFUNCTION CORRECTIVE MEASURES
The milk or water is not flo-
wing correctly into the cup or
cups.
Check that the milk output lid is correctly positioned Fig. 25
Traces of milk are present in
an Americano or Hot Water re-
cipe.
Perform an automatic rinsing cycle, or disassemble and clean the
accessory, before launching the recipe.
When you turn off the ap-
pliance, hot water will come
out of the coffee nozzles and
the One Touch Cappuccino
block.
According to the type of recipe prepared, the appliance can carry
out an automatic rinsing operation when it is turned off. This cycle
lasts only a few seconds and stops automatically.
After emptying the coffee
grounds collector and clea-
ning the coffee drawer, the
warning message is still dis-
played.
Correctly refit the coffee drawer and the coffee grounds collector,
follow the instructions on the screen.
Wait at least for 8 seconds before refitting them.
The coffee comes out too
slowly.
When in operation, turn the grinding setting knob to the right for co-
arser coffee grounds (this can depend on the type of coffee used).
Perform one or several rinse cycles. Launch a clean programme
(see” Coffee circuit automatic cleaning programme" p.
32).
Change the Claris Aqua Filter cartridge (see "Filter installation"
p.26).
After filling the water tank,
the warning message
remains on the screen.
Check that the tank is correctly positioned in the appliance.
Check and unblock the float if necessary. The float at the bottom
of the tank should move freely.
The grinding setting button
is difficult to turn.
Only change the grinding setting when in operation.
The espresso or coffee is
not hot enough.
Rinse the coffee circuit before starting to prepare your coffee.
Increase the temperature of the coffee in the Settings menu.
Heat the cup by rinsing with hot water before starting the prepa-
ration.
The coffee is too clear or
not coarse enough.
Do not use oily, caramelised or aromatised coffees.
Check that the bean tank contains coffee and that it descends
correctly.
Reduce the volume of the preparation, increase the strength of
the preparation.
When in operation, turn the grinding button to the left for finer
coffee grounds.
Prepare your coffee in two cycles using the two cup function.
No coffee is coming out of
the appliance.
An incident has been detected during the preparation.
The appliance is restarted automatically and is ready for a new
cycle.
There is a power cut
during the cycle.
The appliance restarts automatically when reconnected.
Danger: Only a qualified technician is authorised to perform repairs on the power cord
and the electrical network. If this instruction is not followed, you are at risk of
death due to electric shock! Never use an appliance that is visibly damaged!
IFU_KR_EA88_V8_EA88 09/07/15 09:43 Page35