Use and Care Manual

TECHNICAL DATA KRK-39
KRUD KUTTER
®
MOLD & MILDEW
PRESSURE WASHER CONCENTRATE
Form: GDH-922
Rev.: 082415
1
.DESCRIPTION AND USES .
Krud Kutter
®
Mold & Mildew Stain Remover is formulated
to remove tough stains from mildew, mold, algae, fungus
and moss. Strong emulsifying detergents penetrate quickly
into porous surfaces to remove tree sap, bird droppings,
grime and more. Mold & Mildew Stain Remover is ideal for
most exterior surfaces including siding, roofs, gutters,
brick, masonry, stucco, cement block, concrete, wood and
composite.
PRODUCTS .
SKU Description
MM014 1-Gallon Bottle
.PRODUCT APPLICATION .
DIRECTIONS
IMPORTANT – READ ENTIRE LABEL BEFORE USE
 When using a pressure washer to clean painted
surfaces, please be aware that water pressure alone
may remove paint, or highlight existing discoloration
caused by the sun's UV rays.
 From the garden hose, rinse any nearby plants with
clean water.
 Always test on an inconspicuous area first.
 Any overspray can be neutralized with large volumes
of water.
 On extremely soiled or mildewed surfaces, it may be
necessary to scrub with a bristle brush and a second
application may be needed. Mildew stains may not be
completely removed from porous surfaces.
 Do not mix this product with any other chemicals.
COVERAGE
When mixed 1:10 (12 oz. of concentrate with 1-gallon of
water), one bottle of concentrate will make 11 gallons of
premix, and clean up to 3,200 sq. ft.
PRODUCT APPLICATION (cont.) .
DIRECTIONS: PRESSURE WASHER APPLICATION
Rinse surrounding plants with water, before and after
application. Wet surface to be cleaned, prior to applying
the product. Place detergent application siphon tube and
screen filter directly into container. Open meter valve
(if applicable) for maximum product flow. For reservoir
machines, pour product (full strength) into pressure
washer. Spray at low pressure onto a wet surface. On
vertical surfaces, always spray from the top down. Allow
product to remain on the surface for 3 to 5 minutes to
penetrate. Do not allow product to dry on surface.
Remove siphon tube from solution and rinse the surface
with high-pressure spray thoroughly. Flush siphon tube
with clean water prior to storage.
DIRECTIONS: MANUAL APPLICATION
Wet the surface to be cleaned prior to applying the product.
Mix approximately 12 oz. of concentrate with 1 gallon of
water in a bucket. Severe stains may require a larger
amount of concentrate per gallon. Clean in sections with a
soft bristle brush, working from the top down on vertical
surfaces. Work in small sections and allow the product to
remain on the surface for 3 to 5 minutes to penetrate. Do
not allow the product to dry on the surface. Using a hose
set at the highest pressure, rinse the cleaner from the
surface. Move to a new section and repeat the process.
CAUTION! EYE AND SKIN IRRITANT. This product
contains alkaline detergents. Do not take internally. In
case of contact with eyes or skin, flush with water for at
least 15 minutes. If irritation persists, seek medical
attention. If swallowed, take large amounts of water. Do
not induce vomiting. Get medical attention.
KEEP OUT OF REACH OF CHILDREN.