Use and Care Manual

TECHNICAL DATA KRK-21
KRUD KUTTER
®
PARTS WASHER CLEANER & DEGREASER
Form: GDH-540
Rev.: 092616
1
.DESCRIPTION AND USES .
Krud Kutter
®
Parts Washer is formulated with Prevent-X
Corrosion Inhibitor to resist future corrosion, rust and
oxidation caused by the elements. An industrial strength,
aqueous solution it is a safe alternative to hazardous
cleaning chemicals such as mineral spirits and other
solvents.
This multi-purpose formula is designed to be used in
immersion, ultrasonic, manual, and spray applications.
Can be used on aluminum, copper, carbon steel, acrylic,
vinyl, stainless steel, iron, tin, titanium, brass, bronze,
plastic, rubber, powder coated surfaces and more. It safely
and effectively removes grease, grime, oils, carbon, ink
and other organic deposits.
PRODUCTS .
SKU Description
EC012 1-Gallon Bottle
EC05 5-Gallons
EC55 55-Gallon Drum
PRODUCT APPLICATION .
DIRECTIONS
IMMERSION PARTS CLEANER DIRECTIONS:
Pour cleaner into your container to the desired level,
based on the amount of parts to be cleaned. Immerse
parts to be cleaned in the solution. Cleaning time will
depend on type and thickness of soils, and will vary from
minutes to overnight. To determine if items have been
cleaned, periodically lift parts out of container. It may be
necessary to remove heavy soils with a wire brush or
scrub pad, and this can be done over the dipping
container or separate container. Once complete, the soils
will separate from the parts and may float to the top of the
container. An oil skimmer is suggested such as a floating
absorber and should be changed periodically. Final clean-
up can be completed by using compressed air or water
wash.
SPRAY/MANUAL DIRECTIONS:
Can also be used to clean heavy equipment on site. For
heavy soils apply full strength with a pump sprayer or
manual application. For light to medium soils dilute the
product 1 to 10 (12 oz. of concentrate to 1 gallon of water),
or run full strength through a pressure washer chemical
injector or reservoir tank. Allow cleaner to penetrate soils
for 5-10 minutes and wash off. Contains anti-corrosive
agents to safeguard pressure washer parts.
SAFETY INSTRUCTIONS: Rubber gloves and safety
glasses are recommended
CAUTION: EYE AND SKIN IRRITANT. In case of contact
with eyes or skin, flush with water for at least 15 minutes.
If irritation persists, seek medical attention. If swallowed,
take large amounts of water. Do not induce vomiting.
Get medical attention.
KEEP OUT OF REACH OF CHILDREN.

Summary of content (2 pages)